Expand
All| ABS light indication | 3-2 |
| Malfunction code | 3-2 (2) |
| Description of malfunction | Detection of continuous slip for 16 seconds |
| Vehicle status | Not actuated left front wheel ABS |
| Possible cause |
|
| ECU terminals subject to inspect | The 14th and 15th terminals of 18 pin connector |
Detail
- Tuck the wheel sensor until it contacts the sensor ring.
- Do not use a hammer to tuck the wheel sensor.
- To avoid damage, do not pry with a screwdriver or other similar tools.
- If the same code is indicated again after a while of inspection, inspect the clamping bushing for abnormalities and the sensor ring for runout. Make replacement if some abnormalities are found.
- If sensor ring tooth spaces are clogged, use a brush to clean them.
- Confirm the DTC P0108 is inactive
- Start the engine and let it idling condition.
- Verify the DTC P0108 is inactive.
- DTC Clear
- Clear the DTC with Hino DX
- Confirm the same DTC is not reoccurred
- P0108 is reoccur: Return to first process
- Other DTC appear: Refer to concerned Trouble shooting
Complete
